FLRIG on Raspberry Pi4 as RTX Director for Mac OS apps.Yamaha CM500 Replacement Ear Pads Cushions.Thanks to Rob Sherwood for being in time as promised.
I expected a receiver performance in line with the price. Honestly I’m a bit disappointed, since my expectations, reading Yaesu specifications table where much higher. Personally I expected the Yaesu FT DX 3000 for the price being aproximately around 3000 Euros, to have superior receiving performance, considering that the 590 can be found here in Italy at almost half the price and decreading. This confirm the excellent perfomance / price ratio of the 590’s receiver. Table is sorted by dynamic range – narrow spaced, means tat when you are listening to stations with signals close up the one you are focusing, you will hear it better…Īccording to Rob measurements, the latest Yaesu HF transceiver, considering tha dynamic range values, places right under the entry lever line Kenwood TS-590s measured in donwconversion (20 m) and even the smallest FlexRadio 1500 it’s above it. SDRUno and the radio works as expected with no issues.As promised me in November by Rob Sherwood, the new Yaesu FT DX 3000 has been reviewed and added to the world famous Receiver Test Data comparison table. Then after about 30 seconds, the radio will go into TX on its own. The frequency changes as it should in SDRUno and is reflected in the radio if I change VFO on SDRuno. If I make a change in frequency in HRD it changes but SDRUno nor the radio changes. The issue is that HRD loads and sees the VFO frequency, on initial load, however if I change the frequency on either HRD, SDRUno or on the radio itself HRD does nothing.
0 kommentar(er)
